Publicidad
Idiomas disponibles
Idiomas disponibles
Clean
Use clean compressed air to blow away falling particles.
Use wet cotton swab to carefully wipe lens surface.
Use wet sponge or soft cloth to clean product exterior.
Do not rinse thermometer or immerse it in water.
Symptom
OL appears when
measuring
-OL appears when
measuring
Err appears when
booting
Battery indicator flashes
Laser fails to work /
weak laser
The measurement is
inaccurate
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the device
being incorrectly used or, applied for a purpose for whith it was not intended.
According to Waste Electrical and Electronic Equipment directive (WEEE), these ones
must be collected and arranged separately. If you have to throw them out, please, do not use
the usual rubbish. Please, contact your distributor for free recycling.
The maker guarantees to the device owner 12 months against any manufacture defect.
This guarantee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly
filled within one week after purchased the machine to the maker.
------
CORRECT USE
This tool should not be used for work for which it is not specifically designed.
RECYCLING
In order to respect and take care of the environment, it is necessary that all the pieces that
make up this tool are deposited in a specific container or green point for them.
TROUBLESHOOTING
Problem
Measured value is greater
than the maximum range
Measured value is less
than the minimum range
Exceeding the minimum or
maximum operating ambient
temperature
Low battery
Low battery
Emissivity mismatching, measured
distance is too far, measured target
diameter is less than 20mm, etc
NOTES
GUARANTEE
Action
Stop measuring
Stop measuring
Place thermometer in a
0°C~50°C (32°F~122°F)
environment and it can be
recovered after 30 minutes
Replace the battery
Replace the battery
Please refer to the instructions
for field of
view, D:S, etc.
21
Publicidad
