Publicidad
Idiomas disponibles
Idiomas disponibles
Door Removal
In case your home access door is too
narrow for the refrigerator to pass
through, remove the refrigerator doors
and drawers. If you do not need to
remove the appliance doors, proceed to
"Installing Water Lines" on page 10. If
you need to remove the doors, continue
below.
Tools you will need(Not provided)
Allen Wrench (5/32", 4mm)
Philips Screwdriver
Warning
Electrical Shock Hazard Disconnect
power before removing doors.
Reconnect ground wire before
operating. Failure to do so could
result in death or electric shock.
Keep the refrigerator doors closed until you
are ready to lift them from the cabinet.
1.Unplug refrigerator or disconnect power.
2.Using a Phillips screwdriver, remove the
three screws(A) attaching the hinge cover,
and then remove the hinge cover with the
entire harnesses attached.
3. Separate the two connectors on the left
side door. To remove the wire connector,
press the top of the connector (B) and
separate it from the other one. To remove
the water coupler from the hinge, twist
and pull the clips from the coupler.
Remove the water line (C) while pressing
the movable part (D) of the water line
coupler.
Wrench (5/16", 8mm)
4. Remove the 3 screws (E) fixed on the
hinges, with a Wrench (8mm) and 1
ground screws (F) attached to the hinge
with Philips (+) screwdriver. Remove the
upper left door hinge (G).
5. Use our both hands to open the door
more than 90°. Lift it up and take it off.
6. If necessary, remove the 2 hex head
bolts hinges (I) with an Allen wrench
(5mm). Remove the lower left door
hinge (H).
8
Publicidad
