Publicidad
FP4MTP25-3
NOTE: The chain must be running at full speed before
it comes into contact with the wood.
Cut thin branches
Corte de ramas finas
Cut thin branches
Thin branches can be cut off with one single cut. To prevent
Las ramas finas se pueden cortar con un único corte. Para evitar que la rama se astille
Thin branches can be cut off with one single cut. To prevent
the branch from slivering and buckling the branch should be
y se desplome, hay que cortarla en varios trozos (fig. 39).
the branch from slivering and buckling the branch should be
cut off in several pieces. (See Fig. 23)
cut off in several pieces. (See Fig. 23)
Cut thick branches
Corte de ramas gruesas
Cut thick branches
When cutting larger branches, three cuts are necessary as
Al cortar ramas más grandes, es necesario hacer tres cortes, como se explica a
When cutting larger branches, three cuts are necessary as
shown below:
continuación:
shown below:
NOTE: Remove the branches lying on the floor regularly
NOTA: Retire con frecuencia las ramas que haya en el suelo para evitar
to avoid stumbling hazards. Check the oil level regularly
tropezar. Compruebe el nivel de aceite con frecuencia y reposte cuando sea
and fill up if necessary. Switch the power off and
necesario. Apague la máquina cuando la vaya a dejar en el suelo.
disconnect from power source when leaving the product.
First cut into the branch from below, outside of the location
>
1. En primer lugar, haga un corte en la rama por abajo, a cierta distancia del lugar en
>
First cut into the branch from below, outside of the location
where you intend to cut off the branch. The cut should go
el que pretende cortarla. El corte debería alcanzar entre un tercio y la mitad de la
where you intend to cut off the branch. The cut should go
one third to halfway through the branch. (See Fig. 24a)
rama (fig. 40).
one third to halfway through the branch. (See Fig. 24a)
>
Cut into the branch from the top, outside from where the
2. Haga un corte en la rama desde arriba, a cierta distancia del lugar en el que vaya
>
Cut into the branch from the top, outside from where the
branch is to be sawn. (See Fig. 24b)
a cortarla (fig. 41).
branch is to be sawn. (See Fig. 24b)
>
Last, cut off the stump with one clean cut from top to bottom.
3. Por último, corte el tocón con un corte recto de arriba abajo (fig. 42).
>
Last, cut off the stump with one clean cut from top to bottom.
You might want to seal the cut with a suitable compound.
You might want to seal the cut with a suitable compound.
(See Fig. 24c)
40
(See Fig. 24c)
Fig. 24a
>
Puede que quiera sellar el corte con un compuesto adecuado.
Fig. 24a
5059340256009_4-in-1-tool_NoName_A5-IM-V02-ES.indd 49
5059340256009_4-in-1-tool_NoName_A5-IM-V02-ES.indd 49
NOTE: The chain must be running at full speed before
it comes into contact with the wood.
39
Fig. 23
NOTE: Remove the branches lying on the floor regularly
to avoid stumbling hazards. Check the oil level regularly
and fill up if necessary. Switch the power off and
disconnect from power source when leaving the product.
41
Fig. 24b
Fig. 23
42
Fig. 24b
Funcionamiento
Fig. 24c
Fig. 24c
52
11-03-2022 14:58:26
11-03-2022 14:58:26
52
49
Publicidad
