VEVOR E490T Manual Del Usuario página 148

3. Start to cut after the size is entered.then pressing two CUT buttons at
same time ,After that,the clamper come down.When something goes
wrong.stop pressing two CUT button,and press
and blade go back to the top.After confirming the paper is right, press
two cut buttons to finish cutting.
After the cutting is completed, the paper pusher pushes the book
out(automatic push cutting is set).The whole cutting process is
completed.To continue other cuts, you only need to repeat the above
steps.
b. Segmentation mode
Click to switch to bisection mode, click OK, and the paper pusher is
automatically pushed to the first size.When you need to edit the
dimensions, click on the programming mode to enter the first set of
programming modes, as shown in the figure.Need to modify data. click Edit,
click divide Edit, switch divide Edit, switch Dialog Box, modify data.confirm
return.
Push in the cut paper or book and place it on the left to align with the ruler.
Start to cut after the size is entered.Press RESET buttons first,then
pressing two CUT buttons at same time ,After that,the Paper press come
down.When something goes wrong.stop pressing two CUT button,and
press the Paper press and blade go back to the top.After confirming the
paper is right, press two cut buttons to finish cutting.
the clamper