Publicidad
Idiomas disponibles
Idiomas disponibles
After the first cutting , the backguage move to next size automatically.
Continue to press cutting button , to finish cutting in order of setting.
Auto mode operating instructions
Click Auto into auto mode, it is a lot of date as blew picture. And
Click
to turn page. If need to change the date ,edit it in the Auto edit
interface. Click
page or change groups as picture .
Click program control to switch to program control mode, as shown in the
figure above, you can see a lot of data list, click
to turn page,
click Edit to input cutting data, data input.
After entering, click Edit to save data again, and click change module to
switch data of different modules. After clicking
,the paper pusher will
move to the corresponding size, push in and cut the paper or book, and put
the paper or book on the left, which is close to the ruler.
After setting the size, push in the cutting paper or book, and arrange the
paper or book to the left, the edge is in line with the ruler.
After confirming the size, the paper can be cut. Step on the foot switch and
the paper presser starts to press the paper,press the cutting button with
both hands respectively,press the paper to start cutting (or do not step on
the foot switch,press the cutting button with both hands, and the paper
holder starts to press the paper, and then starts cutting after pressing the
paper.If any error is found, release the button, the knife and presser will
return to their original position automatically, and continue to press and
Publicidad
