Tennant IPC PW-E101 Manual De Instrucciones página 30

A
FIG. 11
USING THE CLEANER
CONTROL PANEL
A - On/off switch
B - Temperature regulator
C - Pressure gauge.
STARTING THE CLEANER
1) Turn on the water supply tap (fig. 9A).
2) Connect the water cleaner to the mains electricity
supply by plugging the plug into the socket.
3) Start the cleaner by turning the selector switch to
pos. "I" (fig. 11A).
Warning
The high pressure water jet generates a reaction for-
ce in the lance. Keep a firm grip on the lance handle.
4) Press the trigger on the gun and begin washing.
5) For operation with hot water, refer to the "Control
Panel" booklet.
Warning
In water cleaners with the "Total Stop" system, the
motor starts and stops when the lever on the lance
handle is actioned or released.
Danger
Do not block the handle lever in the delivery position.
IMPORTANT!
To eliminate any impurities or air bubbles from the
water circuit we advise starting the cleaner for the
first time without the lance and letting the water run
out for a few seconds.
Impurities could block the nozzle and cause malfun-
ction (Fig. 12)
Warning
N.B. To reset the indicators, rotate the main swi-
tch "A" to the "0" position and then to the "I"
position (fig.11).
28
OK
ECO
B
C
FIG. 12
For maintenance and/or repairs, use only ori-
ginal spare parts which offer the greatest cha-
racteristics of quality and reliability. Failure to
use original spare parts frees the manufactu-
rer from all responsibility.
USING THE ACCESSORIES.
The high pressure washer has a nozzle with a flat
angle jet for cleaning large surfaces.
ROTARY HEAD (optional accessory)
The high pressure washer can be fitted with a head
with rotary nozzle to clean the most stubborn dirt.
Danger:
Aim the jet from a certain distance to avoid damage
caused by the high pressure.
Do not aim the jet at people, animals or electrical
sockets.
USE OF THE DOUBLE LANCE (fig. 13)
(if available).
The double lance allows the operator to select a low
or high pressure jet. The pressure is selected with
the gun in pos. 1. High pressure: pos. 2. Low pres-
sure.
REGULATING PRESSURE
This chapter concerns only those models provided
with the "pressure regulating" device. The pressure
regulator, fig. 14, allows the operator to adjust the
working pressure. When knob C is turned in an an-
ti-clockwise direction (B) (minimum), the working
pressure is reduced.
USING COLD WATER
It is suitable for removing light dirt or for rinsing ope-
rations on garden tools, walls, balconies, hard floors
in general,etc.
Adjust water pressure according to your needs.
EN - english
IMPORTANT: