Tennant IPC PW-E101 Manual De Instrucciones página 31

FIG. 13
FIG. 14
FIG. 15
USING HOT WATER
For a correct use of the Hot Water, it's advisable to
use the following temperatures:
- Light dirt: 30 - 50 °C:
- Proteic dirt, e.g., in the food sector: 60 °C Max
- Cleaning Automobile or Machine Tools: 60 - 80 °C
- Debinding, Persistent greasy dirt: 80°C
- Facade cleaning, Sanitization of surfaces: up to
80 °C
For adjustments, refer to the "Control Panel".
STOPPING THE CLEANER
1) Switch off the burner by turning the pressure regu-
lator to pos. "0" (fig. 11B).
2) Let the cleaner run with cold water only for at least
30 seconds to cool down the boiler.
3) Stop the cleaner by turning the selector switch to
pos. "0" (fig. 11A).
4) Discharge the pressure from the H.P. hose by
pressing the trigger on the gun.
5) Disconnect the water cleaner from the mains
electricity supply via the Solenoid switch or by un-
plugging the plug from the socket.
6) Turn off the water supply tap (fig. 9A).
Warning
- If the water cleaner is left, even temporarily, turn it
off by using the Solenoid switch or by unplugging the
plug from the socket.
- Water cleaners with the "Total Stop" device should
be considered as off when the Solenoid switch is in
the "O" position or the plug is unplugged from the
socket.
- When the water cleaner is not used, close the sa-
fety device on the handle.(fig. 15).
- Dry use of the water cleaner causes serious dama-
ge to pump gaskets.
ADVICE ON USING DETERGENTS
Warning
This cleaner has been designed for use with the
detergents supplied or recommended by the manu-
facturer.
The use of other detergents or chemicals may in-
fluence the safety of the cleaner.
1) For environmental compatibility, we recommend
a reasonable use of detergents, according to the in-
structions on the pack.
2) From the range of recommended products, choo-
se the one most suited to the washing job to be done
EN - english 29