Nolan N100-6 Seguridad E Instrucciones página 17

multaneously press the mechanism release lever by pressing it downwards (Fig.6),
until the rear grip pawl D1 of the visor comes out from the relevant seat of the
mechanism.
1.3 Actuate the mechanism release lever and pull the visor outwards, so that both
pawls (D1 and D2) and front lockpin (D3) come out of the mechanism (Fig.7)
1.4 Release the visor and slide it upwards to release it completely from the mecha-
nism.
1.4 Follow the previous operations on helmet right side.
2 ASSEMBLY
2.1 Close the chin guard (if open) and set the visor in open position by setting both
pawls (D1 and D2) and front pin D3 in line with the relevant seats on the visor
mechanism (Fig.7).
2.2 Fit the front pin D3 into the relevant seat and press the visor against the mecha-
nism, aligning it with pawl D2.
2.3 Move the visor downwards until rear pawl D1 snaps and locks under the mecha-
nism lever.
2.4 Follow the same steps on the other side of the helmet.
2.5 Close the visor completely.
WARNING
- Check that the mechanisms are working properly. Open the visor. By lifting the
chin guard, the visor should automatically close. If need be, repeat the same op-
erations as mentioned above.
- Check that the mechanisms are working properly. Open and close the visor, mak-
ing sure that it is retained firmly to the side mechanisms. Oopen the chin guard
and check that the visor opens and remains in full opening position. Close the
visor and check that the chin guard closes back to the maximum open position. If
need be, repeat the same operations as mentioned above.
- Do not use the helmet if the visor has not been properly assembled.
- Do not remove the side mechanisms from the chin guard.
- Should any of the side mechanisms fail or be damaged, please contact a Nolan-
group authorized dealer.
MINIMUM OPENING POSITION WITH DEFOGGING FUNCTION
The visor can be slightly opened without making the first mechanism snap. In this
configuration, the inner central pawl of the visor rests on a specific seat on the helmet
chin guard that allows the visor to be kept in a minimum opening position for better
ventilation and making defogging easier, especially at low speed or during short stops.
( NMS-06 )
(Available as standard or as an accessory or spare part)
1 ASSEMBLY
1.1 Disassemble the visor as per instructions above.
1.2 Check that the inner surface of the visor is clean and that the pin adjustment ex-
ternal levers are turned inwards (Fig.8).
INSTRUCTIONS FOR USE
N100-6
17