Nolan N100-6 Seguridad E Instrucciones página 18

N100-6
1.3 Place the PINLOCK
The silicone profile of the PINLOCK
inner surface of the visor.
1.4 Insert one side of the PINLOCK
it in position (Fig.9).
1.5 Widen the visor and fasten the other side of the PINLOCK
pin (Fig.10).
1.6 Release the visor.
1.7 Remove the protective film from the PINLOCK
entire silicone profile of the inner visor adheres to the visor.
1.8 Assemble the visor on the helmet (see instructions above).
2 CHECKING AND ADJUSTING THE STRETCH
Check the correct PINLOCK
and ensuring that they do not move with respect to each other.
If the PINLOCK inner visor is not tightly fixed to the visor, simultaneously move both
®
external adjustment levers upwards to increase the stretch (Fig.8). This operation must
be carried out gradually. The maximum stretch is achieved when the pin adjustment
external levers are turned outwards.
WARNING
- Dust between the two visors may cause both surfaces to scratch.
- Scratched PINLOCK
must therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
moving and scratching both surfaces.
- If the helmet visor fogs up and/or condensation forms between the visors, check
that the PINLOCK
- An excessive and early stretch of the PINLOCK
sive adherence to the visor surface and/or permanent deformations that could
affect any following settings or adjustments.
- An intense sweating, breathing, or use in particular weather conditions - e.g. low
temperatures, high humidity, sudden changes of temperature, heavy rain or an
intense and prolonged use - may affect PINLOCK
causing fogging or mist formation. In such cases, restore the system efficiency
after using the helmet. Remove the PINLOCK
by letting it dry in warm and dry air. Follow the same procedure with the helmet,
letting it dry the same way to remove any humidity formed due to the same condi-
tions above.
3 DISASSEMBLING THE PINLOCK
3.1 DISASSEMBLE THE VISOR EQUIPPED WITH PINLOCK
tions above).
3.2 Widen the visor and release the PINLOCK
3.3 Release the visor.
18
INSTRUCTIONS FOR USE
inner visor on the visor.
®
inner visor onto one of the two visor pins and hold
®
inner visor assembly by opening and closing the visor
®
visors and inner visors may cause reduced visibility and
®
inner visor is both correctly assembled and stretched.
®
®
inner visor must be in contact with the
®
inner visor and check that the
®
inner visor to prevent it from
®
inner visor may result in exces-
®
inner visor performance, thus
®
inner visor from the helmet visor
®
INNER VISOR
inner visor from pins (Fig.10).
®
inner visor to the other
®
inner visor (see instruc-
®