GreenWorks GD60BC Manual Del Operario página 8

6.5 REMOVE THE TRIMMER HEAD
Figure 17 - 18.
1. Put the metal rod in the specified angle transmission
hole to fix the trimmer head.
2. Turn the trimmer head clockwise to loosen it. Do not
remove the spacer from the shaft.
6.6 ASSEMBLE THE TRIMMER HEAD
Figure 17 - 18.
1. Put the metal rod in the specified angle transmission
hole to fix the trimmer head.
2. Assemble the trimmer head.
3. Turn the trimmer head counterclockwise to tighten it.
4. Remove the metal rod.
IMPORTANT
You must install the cut-off blade when you use the
trimmer head.
6.7 REMOVE THE BRUSH-CUTTER
BLADE
Figure 19-20.
WARNING
Apply the guard to the blade.
1. Put the metal rod in the specified angle transmission
hole to fix the trimmer head.
2. Loosen the nut clockwise and remove the outer cup.
3. Remove the brush-cutter blade.
6.8 ASSEMBLE THE BRUSH CUTTER
BLADE
Figure 19-20.
WARNING
Wear gloves and be careful with sharp edges.
WARNING
Apply the guard to the blade.
WARNING
Use the specified Nylon locknut which is packed with
the blade, to assemble the blade.
WARNING
You must change the locknut after you use it for 20
times.
English
1. Put the metal rod in the specified angle transmission
hole to fix the trimmer head.
2. Put the brush-cutter blade on top of the inner cup.
Make sure the blade is in the center.
3. Put the outer cup above the plate.
4. Put the locknut above the outer cup.
5. Tighten the lock-nut counter-clockwise to 44-58"
N.M of torque with a 19mm wrench.
7 TRANSPORTATION AND
STORAGE
7.1 MOVE THE MACHINE
When you move the machine, you must:
• Wear gloves.
• Stop the machine.
• Remove the battery pack.
• Assemble the blade guard.
7.2 STORE THE MACHINE
• Remove the battery pack from the machine and
charge it.
• Make sure that children cannot come near the
machine.
• Keep the machine away from corrosive agents such
as garden chemicals and de-icing salts.
• Secure the machine during transportation to prevent
damage or injury. Clean and examine the machine
for any damage.
7
EN