AdDent Calset Instrucciones De Uso página 4

USER MANUAL
INSTRUCTIONS FOR USE
GENERAL
The Calset unit is designed to heat composite material, anesthetic solution and porcelain
veneers. The Calset unit accepts composite from compules or syringed material. A tray
placed on the top of the heater will either hold compules, or will have a holder for your
composite dispenser. There are other trays available and they are described in Intended Use.
!
Not Sterile.
!
A plastic spatula should always be used to remove composite to avoid
scratching the non-stick surface.
If a tray is used to heat compules, it is recommended that the compule be placed in the com-
posite dispenser immediately after it is warmed and placed in the mouth within 30 seconds.
Warranty registration at www.addent.com.
REPORTING OBLIGATION
Any event such as death or serious injury that has occurred to the patient, user or other per-
sons in relation to use of this device should be reported to AdDent, Inc. and the competent
authority of the Member State in which the user and/or patient is established.
INTENDED USE
The basic Calset unit is used for warming dental composite materials. Accessories for the
Calset are as follows:
Dispenser Tray for other dispensers – for use with 3M, Kuraray, Vident, Centrix Nu-Gun
and Vivadent dispensers.
Anesthetic Tray – Holds 3 anesthetic carpules. For use only with 98°F (37°C)
Temperature setting (Green LED).
Porcelain Veneer Tray – To
Syringe Tray – For composite syringes.
MultiPRO Tray – Flexible configuration, 3 dispensers, 4 compules, syringes and/or finishing
instruments.
Restoration Tray – For warming all adhesively bonded restorations.
2
cement
veneers with composite.