AdDent Calset Instrucciones De Uso página 5

DESCRIPTION OF UNIT
A universal power supply (100-240 VAC, 50/60 hertz) provides power to the heater. A circular
control housing contains a microprocessor and the heater assembly. Around the perimeter of
the housing are the power connector, a control switch, and 2 LED lights. The housing has a
non-stick coated metal top plate to conduct the heat from the heater to the tray. The tray has
a cover and a plastic ring assembly to enable the hot tray to be picked up comfortably. The
Calset will turn off after 10 hours of unattended use.
OPERATION OF CALSET
Plug the universal power supply into a suitable outlet. Connect the power plug into the power
connector MAKING SURE THAT IT IS FULLY SEATED. Put a composite dispenser, syringe,
anesthetic, or porcelain tray on top of the heater. The table below contains a list of the push
button switch functions with regard to temperature and LED color indicators. The push
button will scroll through three temperatures as follows:
Push Button
Push 1st time
Push 2nd time
Push 3rd time
Hold for 2 seconds
The amber (yellow) LED on the right side of the unit turns on when the switch is depressed.
This indicates that the wall plug and power plug are properly connected. The LED on the left
side, a warm up time indicator, will blink according to the table above. When this LED stops
blinking, the selected temperature is reached.
*NOTE: The MultiPRO Tray (P/N 640254) will require an additional 10 minutes warm up
time due to their large size.
Once the Calset Tray has reached desired operating temperature, most composite materials
can be warmed within 3-4 minutes.
OVER TEMPERATURE
The Calset has a back up thermostat that will shut down the Calset if the temperature
exceeds the program value. The lights will go out and the unit will cool down. When the
thermostat resets, it may be possible to re-energize the Calset, but if it shuts down again,
return the Calset for repair.
!
Disinfection
The Calset unit can be disinfected to prevent cross contamination. The
top tray is autoclavable, or can be wiped with a cloth and disinfectant. The plastic housing
should only be wiped using a disinfectant and should not be sprayed. DO NOT AUTOCLAVE
THE BOTTOM HEATER UNIT.
!
METHOD OF STERILIZATION FOR CALSET TRAYS
AdDent, Inc. recommends that the Calset Tray be lightly wrapped and auto
claved. Autoclave cycles for all types of autoclave:
a) Autoclave at the temperature of 121˚ C (250˚ F) for 30 minutes.
b) Autoclave at the temperature of 132˚ C (270˚ F) for 4 minutes.
!
Caution
The Calset operates HOT. Care should be taken to avoid touching hot surfaces.
The tray has a plastic cover and plastic rings for handling. If the tray is to be
taken off the control housing, the heater should be turned off so that the top plate will cool.
This is achieved by holding the control switch in for 2 seconds until the amber light goes off.
The unit will then turn off and the top plate will cool.
LED Color Temperature
Green 98°F (37°C)
Orange 130°F (54°C)
Red 155°F (68°C)
Off
USER MANUAL
Warm up (LED blink) time*
15 minutes
18 minutes
20 minutes
Turn Off
3