Eurocave V-LAPREMIERE-L Modo De Empleo página 28

Precautions (Continued)
• For single-temperature models only:
- If you notice low humidity levels (<50%) a few days after setting
your wine cabinet into operation, we recommend that you use the
humidity cartridge, supplied in a bag with the appliance. Place it at
the bottom of the cabinet, under the rack in the drip tray provided
(see diagram below). When using for the first time, completely
immerse your cartridge in tap water for a few minutes to saturate
it then allow it to dry. Depending on external conditions, it may
be necessary to add a 10cl glass of water after several months.
- If you notice that the humidity level is too high, remove the black
drain pipe located at the bottom of the cabinet and the humidity
cartridge if you installed one .
• Install the stop (which is located in the accessories bag) at the back of
the cabinet (see diagram).
• This allows a space of 7 cm
to be maintained between
the wall and the rear of the
cabinet. This space allows your
cabinet's power consumption
to be optimised.
• Place the 2 caps in the 2 holes
at the top of the cabinet.
• Do not push the caps all the
way in, in order to allow the
rear stop to be installed.
• Slide the rear stop between
the caps and the wall of the
cabinet, then push the 2 caps
all the way in.
8
GB
4/ INSTALLING YOUR WINE CABINET
Installation
Place your cabinet in the desired location.
It must:
• be open to the outside and well ventilated (not in an enclosed cupboard,
for example),
• not be too damp. (linen cupboard, laundry room, bathroom...),
• have a flat, stable floor,
• be supplied with power (standard outlet, 16 A, earthed with 30 mA*
circuit breaker). (* not applicable to some countries).
• Place your cabinet in the desired location.
• Fit the charcoal filter (located in the "accessories" bag) by inserting it
into the breather hole located on the top left-hand side of the inside
of your cabinet.
• Wait 48hrs before plugging in your cabinet
• When using your cabinet for the first time, the charcoal filter alarm will
display. Reset the filter meter to 365 (see chapter 6, § VII).
Installation of two cabinets side by side
Caution: In the case of two side by side cabinets installed in extreme
conditions (Temperature >30°C - Relative Humidity > 70%), in order to
prevent condensation of stagnant air between the walls, please leave either
a minimum space of 5 cm between the two cabinets, or fill the space with
a foam sheet to remove the void.
Door security
In order to make your cabinet secure, all doors have a lock. You will find
the key for this type of lock (figure 2) in your accessories bag.
1
Bottles must be arranged so that they do not come into
contact with the back wall. If this happens, the condensation
created on the wall may trickle onto the shelves and damage
the bottle labels. In addition, contact with the cold wall may create a
frost point, which is harmful to your wine.
2