Alecto BFT-66 Manual página 5

5.2 Warnings
Lid is not properly attached
6. CLEANING AND MAINTENANCE
• Clean the appliance immediately after each use.
• ALWAYS remove the plug from the socket during cleaning and allow the appliance to cool down.
• Carefully unscrew the blade unit from the jug (see chapter 5.1. ASSEMBLY AND DISASSEMBLY) in order to clean the loose parts thoroughly.
Caution! The blade unit is sharp. Pay special attention when assembling, disassembling and cleaning it.
• The base can be wiped with a damp cloth.
• NEVER immerse the base in water and do NOT rinse under the tap!
• NEVER place the base on a wet surface.
• NEVER use scouring pads, abrasive cleaners, bleach or aggressive liquids such as gasoline, acetone or alcohol to clean the device or
accessories.
• Hard water causes deposits in the water tank. We recommend removing this limescale every 2-4 weeks. Descaling should ONLY be done with
white vinegar. Caution! Make sure the appliance is completely turned off and no longer hot. Follow the instructions below:
1. Pour the white vinegar solution (60 ml white vinegar and 60 ml water) into the water tank until it is half full and screw the lid onto the water
tank.
2. Allow the solution to stand for approximately 6 to 12 hours until the limescale has completely disappeared. If the limescale is not completely
dissolved, repeat the previous steps until the water reservoir is completely clean.
3. Pour the solution out of the water tank and rinse well with water. Rinse the lid well under the tap.
4. Fill the water tank with 250 ml of water (up to the MAX indication) and go through 1 steam cycle without ingredients, before you resume
preparing food.
5. Finally, dry the water tank with a soft cloth.
• Rinse all parts ONLY by hand. DO NOT put in the dishwasher.
• Dry all parts before replacing and storing them.
• All parts that come into contact with food, such as the steam basket, the spatula and the jug may discolour. This is normal and not harmful to
the preparation of the food.
• The BFP-66 requires no maintenance other than cleaning and descaling.
60
E1 - misplacement of Lid or Jug
The appliance has a built-in safety lock. If the lid is not properly placed on the jug or the jug is
not properly placed on the base during use, the warning message "E1" will appear on the
control panel. The steam and blender function cannot be activated in such a case.
E2 - Watertank
If the water in the water tank is used up during steaming, the warning message "E2" will appear
on the control panel. The thermostat will switch off followed by 3 beep tones. If the water is
replenished within 2 minutes, the steam function will automatically resume where it left off
within a few seconds. If no water is added, the BFP-66 appliance will automatically return to
standby mode.
Standby mode - Horizontal stripes
In standby mode, the horizontal stripes flash and no function is activated. To completely turn
off the control panel, unplug the power cord or press the power/pause button for approximately
3 seconds.
2
120
4
3
Jug is not properly attached
5
6