Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope your new tool brings you much enjoyment and
success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling
• Non-compliance of the operating instructions
• Repairs by third parties, by not authorized service
technicians
• Installation and replacement of non-original spare
parts
• Application other than specified
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regulations
and VDE regulations 0100, DIN 57113 / VDE0113
Please observe the following:
Read through the complete text in the operating in-
structions before installing and commissioning the
device.
The operating instructions are intended to help the user
to become familiar with the machine and take advan-
tage of its application possibilities in accordance with
the recommendations.
The operating instructions contain important informa-
tion on how to operate the machine safely, profession-
ally and economically, how to avoid danger, costly re-
pairs, reduce downtimes and how to increase reliability
and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in your
country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information.
28 | GB
The machine can only be operated by persons who
were instructed concerning the operation of the ma-
chine and who are informed about the associated dan-
gers. The minimum age requirement must be complied
with.
In addition to the safety instructions contained in this
operating manual and the specific regulations of your
country, the technical rules generally accepted for the
operation of machines of the same type must be ob-
served.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions and
the safety information.
2. Device description (fig. 1-18, 24)
1.
Saw table
2.
Transverse stop
3.
Riving knife
4.
Saw blade guard
5.
Saw blade
6.
Table inlay
7.
Parallel stop, complete
8.
Hand wheel
9.
Locking handle
10. Overload switch
11.
On/off switch
12. Rubber foot
13. Tool hook
14.
Push stick
15. Locking knob
15a. Clamping plate
16. Holder
16a. Screw (parallel stop)
17.
Stop rail
18. Knurled screw (transverse stop)
19.
Turning handle
20. Ring spanner, 7/8 mm
21.
Ring spanner, 19/10 mm
22. Table width extension
23. Guide tube
24. End piece
25. Screw (end piece)
26. Knurled screw (table width extension)
27.
Guide bushing
28. Height adjustment screw
29. Lock nut
30. Support foot
31.
Hole (riving knife)
32. Screw (table inlay)
33. Fixing screw (riving knife)
www.scheppach.com
Publicidad
