Publicidad
Idiomas disponibles
Idiomas disponibles
EN
CORDLESS HOT KNIFE CUTTER
Introduction
The COLOTOOL
battery heated knife is a professional quality tool for hot cutting of insulation systems. The tool heats up in
®
seconds and the user can control the temperature from the tool itself.
Recommended use
Expanded polystyrene (EPS), extruded polystyrene (XPS), polyethylene, cross-linked polyethylene, polypropylene and other
foamed plastic materials.
Characteristics:
Input
Output
36 V DC
72 Wh
Blade installation
NOTE: Make sure that the mains cable is disconnected from the power supply before handling the blade. Also, make sure that
the blade is not hot before handling.
Caution 1: The edges of the blade are extremely sharp. For a clean cut, always make a clean cut using these edges.
1. Loosen the screws of the blade holders with the wrench.
blade holders with the spanner.
2. Slide the blade under the square pressure plates until it is
Slide the blade under the square pressure plates
until it is securely clamped.
3. Tighten the screws securely to
Ensure proper electrical connection.
It is not necessary to overtighten.
4. The temperature control knob has 16 settings which
correspond to the graduations marked on the wheel surface.
Caution 2: Excessive power output and heat generation may cause the blade holders to overheat which could damage the unit.
Use only the power output for proper cutting. The blade does not have to be red hot to make cuts.
Operating
Set the temperature control to the middle power setting, place the blade against the edge of the foam and press the trigger. For
optimum cutting, virtually no smoke should appear.
NOTE: To obtain satisfactory results, test the tool first.
Intermittent operation
15 " ON / 45 " OFF
E
B
F
Weight
Length
283 gr.
260 mm
A
C
D
Ref. 25043
Temperature
350 ºC
A) Temperature control
B) Trigger
C) Trigger lock
D) Battery lock
E) Blade support
F) Battery
Publicidad
