geberit 116.072.00.1 Manual De Operación página 18

EN
Replacing the urinal trap
For hygiene reasons, replace the urinal trap
at least once a year.
Prerequisite
– Cleaning mode is activated.
– Refer to figure sequence
while carrying out the instructions.
1
Demount the cover for the urinal trap.
2
Demount the urinal trap.
3
Replace the urinal trap (art. no.
243.312.00.1) and the cover for the
urinal trap (art. no. 243.314.00.1).
4
Mount the urinal trap.
5
Mount the cover for the urinal trap.
Cleaning or replacing the
basket filter
• Clean the basket filter in the solenoid
valve at least every 2 years or if the flush
volume decreases.
• Descale the basket filter with a
commercially available descaling agent if
necessary.
• Replace the basket filter if it can no
longer be completely cleaned and
descaled.
Prerequisite
– Refer to figure sequence
while carrying out the instructions.
1
Demount the urinal flush control. →
See figure sequence
2
Demount the securing clamp.
3
Demount the coupling.
4
Remove the basket filter.
18
4 , page 262
5 , page 263
1 , page 259.
5
Clean, descale or replace the basket
filter.
6
Install the basket filter.
7
Mount the coupling and snap in the
solenoid valve.
8
Mount the securing clamp.
9
Mount the urinal flush control. → See
figure sequence
Result
✓ The urinal is ready for operation.
Setting the flush time
The flush time can be adjusted to suit the
user's needs using a Geberit app.
Optimising the detection
distance
If flushes are actuated too soon, too late or
unintentionally, you can optimise the
detection distance of the IR sensor with a
Geberit app.
Restarting the urinal flush
control
▶
Disconnect the mains voltage for
approximately 30 seconds.
✓ If necessary, switch the fuse in
the electrical distributor off and
on again.
Result
✓ The urinal flush control restarts.
45035999387605899 © 02-2022
2 , page 260.
970.647.00.0(01)