Publicidad
Idiomas disponibles
Idiomas disponibles
DANGER:
• This appliance must be connected to the power supply in accordance with the voltage and phase
shown on the appliance nameplate, do not attempt to connect the appliance to a different power
supply, the electrical connections should be made by a qualified electrician.
WARNING:
• Connecting the appliance to the wrong power source may damage the appliance and void the
warranty.
• Electrical connections to this appliance must comply with local and national codes and
regulations.
DANGER:
• In order to avoid electric shocks, the appliance needs to be sufficiently earthed, and
the earthing connection must be made in such a way as to ensure that the power cable is
connected to the earth terminal when it is subjected to an external force. Inside the electrical box
of the appliance there is a grounding screw with the following general symbol.
• The device is equipped with an equipotential connection bolt to which a balanced connection lead
must be connected to provide adequate protection against potential differences. This bolt is
located at the rear of the appliance and has the following generic symbol next to it.
WARNING:
• When connecting the power cord, make sure that each core is firmly connected and lock the
power cord. Even when the power cord is subjected to external force, the terminals should not be
loosened by external force, otherwise it may cause danger. The power supply cord shall be an
oil-resistant sheathed cable, not lighter than ordinary neoprene or other equivalent synthetic rubber
sheathed cord (YZW), and if the power supply cord is damaged, it must be replaced with a power
supply cord of the same specification.
• The electrical wiring of the equipment must be connected to a separate supply circuit by a
qualified electrical installer. Each appliance must be fitted with a double insulated switch of
suitable rated capacity with a contact spacing of more than 3 mm.
• If the power supply is outdoors, please pay attention to the waterproof and dustproof protection
measures of the power supply.
• To prevent the power cord from fraying and causing a hazard, the power cord must be fitted with
a coil guard at the outlet of the unit and at the hole through which the power cord passes.
• When the power cord is not long enough, prepare a new dedicated power cord of sufficient
length.
7/15
NOTE:
If in doubt about power supply requirements and
power installation, consult a technician qualified
as an electrician.
Publicidad
