Contest VERSATILE COLOR CPANEL-200RGBL Guia Del Usuario página 27

VPANEL-200RGBL -
6.7 - VRDM-Split splitter :
The VRDM-Split is a DMX RDM 1xIN 2x OUT IP66 splitter. It reboosts the incoming DMX signal on two RDM-compatible DMX outputs. It has a
Hybrid Power/DMX input on which the DMX signal will be extracted in order to be divided into two separate isolated and protected lines.
The Hybrid input supply will be disconnected and a new Power IN supply will be injected on the two Hybrid outputs.
DMX/POWER IN
AC 100-240V 50/60Hz
FUSE: T3A/250V 200W
Distributed by HITMUSIC SAS
MADE IN CHINA
IN
VRDM-Split en mode hybride
D+ D- GND
DMX-IN
L N
Disconnect
Power
Hybride
POWER+ DMX IN
Hybride
Power + DMX OUT1
IP66 architectural projector with 24 LEDs 20W 4in1 RGBL
DMX/POWER OUT
MAX: 10A
architectural-lighting.eu
FRANCE
VRDM-Split
OUT
D+ D- GND D+
DMX-IN DMX-OUT1
L N L
Disconnect Power Power OUT1
IN
OUT1
DMX/POWER IN
AC 100-240V 50/60Hz
FUSE: T3A/250V 200W
IN
Contest Architectural Lighting
VRDM-Split
D+ D- GND D+ D- GND
DMX-OUT1 DMX-OUT2
L L
N N L N
Power OUT1 Power OUT2
Power INPUT
16A (3500W max)
Power + DMX OUT2
Contest Architectural Lighting
VRDM-Split
D- GND D+ D- GND
DMX-OUT2
N L N L N
Power OUT2 Power INPUT
Power IN
OUT2
DMX/POWER OUT
MAX: 10A
architectural-lighting.eu
Distributed by HITMUSIC SAS
FRANCE
MADE IN CHINA
OUT
The Hybrid Power+DMX IN input on the left is used to recover the
DMX signal which will be filtered, divided and protected.
The power supply will be disconnected from the circuit via the
Disconnect Power connector.
The Power IN input on the right is used to supply the splitter and to
re-inject the supply into the outputs.
Outputs OUT1 and OUT2 therefore have a reboosted DMX signal
and power supply to start new lines.
Note :
In this case, the VRDM-Split is used in a Hybrid 1 x IN, 2 x OUT
configuration.
It is possible to use the VRDM-Split simply by entering with a DMX
IN signal to 2 x DMX OUT and supplying the box with power IN
Power IN
only.
It is also possible to mix the two combinations for more flexibility.
Hybride
CAUTION !
The sum of the powers of the different lines must
not exceed the power of the Power input (3500W).
The power per line is limited to the characteristics
of each of the devices, see table in the section on
chaining of projectors.
IN
DMX/POWER IN
AC 100-240V 50/60Hz
FUSE: T3A/250V 200W
architectural-lighting.eu
Distributed by HITMUSIC SAS
FRANCE
MADE IN CHINA
English
DMX/POWER OUT
MAX: 10A
OUT
Page 27