AgfaPhoto Realishot VLG-4K Manual De Usuario página 9

MICROPHONE
1
5
+ AAA Battery I
1. Wind cap
2. Tripod plug
3.
Indicator light
4. Power Switch / dB Slider
5. Battery cover
6. 5 mm Audio cable
How to use your microphone
1. Open the battery compartment, then install an AAA
1.5V battery correctly according to the positive and
negative poles marked on the compartment.
2. Mount the Tripod Plug to the base of Tripod
and turn the connector clockwise to tighten
it. Connect the microphone to the camera by
inserting the Audio Cable to the camera.
3. Plug the Audio Cable of the microphone into
the MIC connector of the device and turn on
the microphone Power Switch.
4. Slide the Power Switch/dB Slider back and
forth to turn on microphone and switch
between 0dB and 20dB.
Note: If microphone is connected to camera and
to be powered off, no sound will be recorded.
4
3
2
6
SPECIFICATIONS
Channel
Use Voltage
Output impedance
Battery life
Maximum sound
pressure level
Microphone
Frequency response
Sensitivity
enhancement
Sensitivity
Equivalent noise
level
EN
Stereo
AAA 1.5V Alkaline
battery
200Ω±30% (at 1kHZ)
20~30 hours.
130dB (THD ≤1.5%
at 1kHZ)
Electrostatic
capacitor microphone
50HZ-16kHZ
+20dB±2dB
-45dB±3dB(0dB=1V/
Pa at 1kHZ)
24dB A
9