Publicidad
Idiomas disponibles
Idiomas disponibles
202161_s1_s1_5059340093833-5059340093840_C&L_A5_IM_Multi_V04.pdf, Cycle:5, Status:Approved
SOFTWARE CONFIGURATION
1.
Turn on the hob using the ON / OFF key. The
hob will show "-" on each cooking zone.
2.
Touch the front left zone key and the Timer
key together for three seconds. The hob will
beep and show "5" in the timer display.
3.
Touch the Timer key once and the display will
change to "5E".
4.
Touch the front left zone key and the Timer
key again and the two front zones will
indicate "2" and "8". This is the factory setting
of 2800 W.
5.
Touch the front left zone key to switch the
display to "6" and "4". This indicates high
power at 6400 W.
6.
Touch the Timer key again to finish
configuration.
Note: If required, the hob can be converted back to a plugged version by following the cable
conversion and software steps above again.
202161_s1_s1_5059340093833-5059340093840_C&L_A5_IM_Multi_V04.indd 15
202161_s1_s1_5059340093833-5059340093840_C&L_A5_IM_Multi_V04.indd 15
Printed by Henry Leung, 06/05/2021 01:52:54
15
28-04-2021 17:43:07
28-04-2021 17:43:07
page 16 of 108 pages
Publicidad
