Publicidad
Idiomas disponibles
Idiomas disponibles
202161_s1_s1_5059340093833-5059340093840_C&L_A5_IM_Multi_V04.pdf, Cycle:5, Status:Approved
Controlling the cooker hood remotely
01
Before First Use
This induction hob model and a compatible cooker hood model must be paired by Radio Frequency
(RF) before remote control can occur.
When connected the power output of the induction hob will control the extraction rate of the cooker
hood.
02
To Set Up Connectivity:
1. Make sure that the hob and the hood are switched off.
2. Press the Timer icon
display will alternately fl ash red and white.
3. Turn on the hob and make sure the connectivity indicator is lit red.
4. Press the keys
connection.
5. The control panel of the hood will show A for five seconds to indicate connectivity has been
made with the hob.
6. Press the keys
202161_s1_s1_5059340093833-5059340093840_C&L_A5_IM_Multi_V04.indd 52
202161_s1_s1_5059340093833-5059340093840_C&L_A5_IM_Multi_V04.indd 52
Printed by Henry Leung, 06/05/2021 01:52:54
IMPORTANT: This section is only applicable if you have also purchased a
compatible cooker hood with Radio Frequency (RF) capability. Contact the
Customer Helpline at the end of this manual for compatible models.
and Light icon
NOTE: Touch the connectivity key
and
together on the hob and the connection indicator will flash to confirm
and
together on the hob one more time to store the connectivity settings.
IMPORTANT: The connectivity operation above must be completed within two
minutes of turning on the power to the hood. If this is not successful, switch off both
the hood and the hob, wait for one minute and attempt the connectivity again.
together on the control panel of the hood. The LED
on the hob if it is not lit.
52
28-04-2021 17:43:17
28-04-2021 17:43:17
page 53 of 108 pages
Publicidad
