Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING AND ADJUSTING THE AUXILIARY HANDLE
WARNING:
assembling parts, making adjustments, cleaning, or when the product is not in use.
1. Stop the motor and remove the battery pack, if installed.
2. Loosen and remove the quick-release lever, clamping block, and wing nut from the
auxiliary handle (Fig. 2a).
3. Push the auxiliary handle onto the shaft within the mounting zone between the
shoulder strap loop and front handle. Make sure that the auxiliary handle is
positioned upwards and points toward the top of the rear handle.Then insert the
clamping block into the handle slot (Fig. 2b).
4. Mount the quick-release lever and tighten the wing nut (Fig. 2c).
5. Pull the quick-release lever up to move/rotate the auxiliary handle to a comfortable
operating position (Fig. 2d).
NOTICE: The auxiliary handle should be positioned on the shaft only within the
mounting zone.
6. Engage the quick-release lever to secure the auxiliary handle in place.
2a
Clamping Block
2c
Quick-release Lever
Wing Nut
22
56-VOLT LITHIUM-ION COMMERCIAL 21" ARTICULATING POLE HEDGE TRIMMER — HTX5300-PA/HTX5300-PA-FC
Always remove the battery pack from the product when you are
Auxiliary Handle
Quick-release Lever
Wing Nut
2b
Shoulder Strap
Loop
2d
a
b
Auxiliary Handle
a
Front Handle
b
Clamping Block
Publicidad
