Publicidad
Idiomas disponibles
Idiomas disponibles
UNFOLDING AND FOLDING THE
CUTTING BLADES
Unfolding the cutting blades
1. Ensure that the blade sheath is in place
and the battery pack is disconnected
from the hedge trimmer.
2. Push the lower part of the hand guard
back to release the tip protector from
the support block on the hand guard
(Fig. 4a).
3. While pressing the release lever, rotate
the blade-angle handle to unfold
the cutting blades, from the storage
position to the desired cutting position
(Fig. 4a & 4b).
4. Release the release lever. An audible
click indicates that the locking pin is
engaged in one of the detents.
Folding the cutting blades
(Fig. 4c)
1. Ensure that the blade sheath is in place
and the battery pack is disconnected
from the hedge trimmer.
2. While pressing the release lever, rotate
the blade-angle handle to fold the
cutting blades next to the shaft.
3. Release the release lever.
4. Push the lower part of the hand guard back to allow the tip protector to enter, then
release the hand guard to ensure the tip protector rests on the support block.
24
56-VOLT LITHIUM-ION COMMERCIAL 21" ARTICULATING POLE HEDGE TRIMMER — HTX5300-PA/HTX5300-PA-FC
Tip Protector
4a
Storage Position
4b
Locking Pin
a
Blade-angle Handle
Release Lever
4c
Cutting Position
Support Block
Hand Guard
a
b
b
Detent
Publicidad
