Makita EM403MP Manual De Instrucciones página 10

Installing the nylon cutting head
CAUTION:
If the nylon cutting head hits
against a stone during operation, stop the
motor and check the nylon cutting head
immediately.
1. Put the receive washer on the shaft.
2. Insert the hex wrench through the hole in
the gear case.
3. Screw the nylon cutting head onto the shaft.
4. After installing nylon cutting head, remove
the hex wrench.
1
2
► 1. Nylon cutting head 2. Receive washer
3. Shaft 4. Hex wrench 5. Tighten
Mounting the attachment pipe
Mount the attachment pipe to the power unit.
1.
Turn the lever toward the cutting
attachment.
► 1. Lever
2.
Align the pin with the arrow mark and insert
the attachment pipe until the release button pops
up.
5
3
4
1
► 1. Release button 2. Arrow mark 3. Pin
3.
Turn the lever toward the power unit.
► 1. Lever
Make sure that the surface of the lever is parallel
to the pipe.
To remove the pipe, turn the lever toward the
cutting attachment and pull the pipe out while
pressing down the release button.
Fig.12
► 1. Release button 2. Lever 3. Pipe
10 ENGLISH
1
2
3
1
1
2
3