Makita EM403MP Manual De Instrucciones página 8

Installing the protector (cutting tool
guard)
WARNING:
Do not use a cutting tool
without an appropriate protector at any
time.
WARNING:
Always use the cutting tool
with the correct combination of the protec-
tor. Otherwise contact with a cutting tool may
cause serious injury.
NOTICE:
Periodically tighten the bolts
on the protector. Tighten the right and left
bolts evenly so that the gap between the
clamp and the protector is constant.
Fix the protector to the clamp with bolts.
Protector (universal type)
2
► 1. Clamp 2. Protector
Protector (narrow type)
► 1. Clamp 2. Protector 3. Cutter
1
1
2
3
CAUTION:
yourself with the cutter mounted on the
protector.
NOTE: The cutter on the protector keeps the
nylon cord best length for cutting.
For EM403MP and EM404MP
To install the protector extension, insert the pro-
tector extension to the protector and then snap
the clips on. Make sure that the tabs on the pro-
tector extension fit into the slots on the protector.
1
2
3
► 1. Protector (universal type) 2. Clip
3. Protector extension 4. Cutter (inside)
5. Slot 6. Tab
To remove the protector extension from the pro-
tector, unclasp the clips and pull the protector
extension out.
CAUTION:
protector extension until it is fully inserted.
Otherwise the protector extension may fall and
result in personal injury.
CAUTION:
self with the cutter mounted on the protec-
tor extension.
NOTE: The cutter on the protector extension
keeps the nylon cord best length for cutting.
Installing the cutting tool
CAUTION:
MAKITA cutting tools.
CAUTION:
wrench after installation.
NOTE: When installing the cutting tool, turn the
tool upside down for ease of the procedure.
8 ENGLISH
Be careful not to injure
4
6
Make sure to push in the
Be careful not to injure your-
Be sure to use genuine
Make sure to remove the hex
5
2