Publicidad
Idiomas disponibles
Idiomas disponibles
Inflatable Products – Aquaglide makes some of the highest quality inflatable products in the world. With
proper care and maintenance, our products are expected to last for years under normal use. We list important
tips and instructions below. If unsure about any point, please reach us through our website at Aquaglide.
com/contact-us.
Note: see Anchoring instructions (below) before inflating this item. Strong winds can make it difficult to control
this product. Be aware of weather conditions before installation.
Air Pump - Use an air pump recommended for inflating your product. For products this size, use of a high-
volume electrical pump is best. Air pressure requirements are low – 5.0psi (0,35bar) or less. Air compressors
designed for high-pressure inflation are not recommended because they can easily lead to over-inflation.
Valve(s) – This product uses Halkey Roberts – type (HR) valves. Valve attaches to product using a threaded
backing plate, making it easily replaceable in the unlikely event of damage.
Access valve using a coin or flat tool to twist the tamper-resistant cap counter-
clockwise. To close, insert the cap and twist clockwise using the same tool.
Note: cap is the secondary air seal. See A.
To inflate, an air pump with Halkey Roberts – type (HR) valve fitting is required.
Insert fitting into valve and twist clockwise to lock in place. See B.
Valve Operation: To operate Halkey Roberts – type (HR)
valve, press plunger and turn 90 degrees to set valve for
inflate and product use (plunger out = 1-way airflow). Press
plunger and turn 90 degrees to deflate (plunger in = 2-way
airflow). Note: valve is primary air seal. After inflation, close
with cap for secondary seal. See C.
Proper Working Pressure for each chamber is listed
below. Do not overfill or underfill. Excessive pressure can
cause damage to the product and may void the warranty.
Do not use without adequate air pressure. Product can
become unstable if underfilled and may not support
indicated capacity. Use a pressure gauge (manometer) to
carefully monitor air pressure in the product especially during
hot or cool periods.
Chart 1 – Working Pressure by Chamber - FIGURE 8
Valve [Inflate Order]
MAIN [1]
TUBES [2]
1. Locate a flat, dry area with access to outlet for electrical pump. The best setup position will also make
launching easy. Never drag product as damage may occur.
2. Unfold product completely and locate Main Valve [1]. To help future storage, closely note original folding &
packaging method. Remove valve cap and confirm valve is in inflate (1-way airflow) position.
3. Insert air pump hose with proper valve fitting into Main Valve [1], lock into place. Use pump to inflate Main
Valve [1] to Working Pressure as shown in Chart 1.
4. Repeat step 3 instructions to inflate each chamber to proper Working Pressure shown in Chart 1 until all
chambers are properly inflated.
6
ASSEMBLY
Working Pressure in psi (Bar)
2.0psi (0,138bar)
2.5psi (0,172bar)
A
B
C
Inflate (1-way)
www.aquaglide.com
Deflate (2-way)
Publicidad
