Publicidad
Idiomas disponibles
Idiomas disponibles
g) Follow all charging instructions and do not charge the battery pack or tool outside the
3.6 SERVICE
a) Have your power tool serviced by a qualified repair person using only identical
b) Never service damaged battery packs. Service of battery packs should only be performed by
3.7 ELECTRICAL SAFETY (BATTERY 81100)
Charge the battery only with the charger 104519 supplied by ENAR.
Make a full charge of the battery before using it.
Do not overcharge the battery. Once the LED indicator on the charger changes its status to
GREEN, unplug the connector from the charger and then, disconnect the charger from the mains.
Never subject the equipment to impacts.
Never open the battery, neither manipulate the connections.
Do not expose batteries to sources of heat or fire.
Operation temperature of the battery is between -10ºC and 45ºC.
Do not expose the battery to rain or wet conditions. Keep it clean and dry.
Clean carefully the contacts of the battery with a clean and dry cloth in case they get dirty.
Never short-circuit the battery.
If the battery is to be stored for long periods of time, a full recharge should be performed every 3
en
months.
Batteries must be stored in a dry place and away from the direct sunlight.
Never store batteries in hazardous locations where they can short-circuit to each other or through
other conductive materials.
Keep the battery away from children.
Keep the battery away from small metal objects that can cause a bridge connection between
contacts. It may cause a short circuit and a battery fire.
3.8 ELECTRICAL SAFETY OF THE CHARGER
Use only the battery charger 104519 of ENARCO to charge the battery.
Before using the charger check the cable and the plug are in good condition.
The plug must fit the socket of the power source.
Do not abuse the cable. Never use the cord to carry, lift, or unplug the charger.
Disconnect the charger when is not in use.
Never use a damaged charger. It can cause battery failure and / or user injury from electric shock.
Never open the charger, neither manipulate the connections nor the plug.
If you detect any electrical damage to the charger, contact the technical service of ENARCO or an
authorized dealer.
Charge only the battery of the BOXEL E-BATT by ENAR.
Do not overload the charger of the battery. Once the LED indicator on the charger changes its
status to GREEN, remove the battery connector and disconnect the charger from the mains.
Do not subject the charger of the battery to impacts.
BATTERY POWERED ELECTRONIC CONVERTER
SPYDER E-BATT
8
temperature range specified in the instructions. Charging improperly or at temperatures
outside the specified range may damage the battery and increase the risk of fire.
replacement parts. This will ensure that the safety of the power tool is maintained.
the manufacturer or authorized service providers.
Publicidad
