Publicidad
Idiomas disponibles
Idiomas disponibles
Do not expose battery charger to sources of heat or fire.
Charging temperature of the battery is between 0ºC and 45ºC.
Do not expose the battery charger to rain or wet conditions. Keep it clean and dry.
Clean carefully the contacts of the charger with a clean and dry cloth in case they get dirty.
The charger must be stored in a dry place and away from the direct sunlight.
Never use the charger over flammable materials or in explosive environments.
Never use the charger down the direct sunlight neither at temperatures below 0ºC.
Never force the plug of the charger, it must fit smoothly in the power point.
Never modify the charger plug or use mains adapters.
Keep the charger away from children.
Keep the power cable and the charging cable clean and avoid them to contact with oils or corrosive
substances.
Keep the power cable and the charging cable away from cutting edges.
Never use the cable neither the plug to carry the charger.
3.9 SPECIFIC SAFETY RULES
For the proper use of this device, make sure that the operator has been correctly informed of the
content of this manual before using it.
This converter must be used only under the applications for which it has been designed and
according to these safety instructions.
Before connecting the converter to the vibrator, make sure that the voltage and frequency of the
vibrator coincide with the ones stated in the characteristics plate of the converter.
Ensure that all converter screws are tight before starting work.
Be sure that the parts of the poker are tight before starting work (welding points).
Keep the converter clean and dry
The device does not make noise by itself. Proper protective equipment must be used when
connecting a vibrating poker.
The device does not generate vibration. It must be checked the vibration level of the connected
poker in the user's manual of each vibrating poker.
When finishing the job or when taking a break, the operator must switch the vibrator off and place it
in a such way that should not fall or tip.
FURTHERMORE, THE OPERATOR IS COMPELLED TO RESPECT ADDITIONAL REGULATIONS ENFORCED
4
OPERATION AND MAINTENANCE
4.1 GETTING STARTED
1.-
Before starting work, the correct operation of all handling and safety devices must be checked.
2.-
Check that all the screws are well tightened.
3.-
Check the battery charge status.
4.-
Operate converter switch and carry out the work
5.-
After the work is finished, clean the converter and the remains of fresh concrete adhering to it.
Do not use pressurized water to clean the converter.
6.-
Connect the vibrator to the converter.
7.-
When a defect or a malfunction has been detected, endangering the use of this machine or
not, stop the work and make the correspondent maintenance to avoid any danger or bigger
damage.
BATTERY POWERED ELECTRONIC CONVERTER
SPYDER E-BATT
en
9
Publicidad
