GYS 067158 Manual De Uso página 20

Operating manual
20
Translation of the original
instructions
K0848 1 Welded winch support
55580 2 Support leg
70500 1 Lifting winch
/ 1 Wheel attachment
/ 2 Caliper attachment
/ 2 Battery attachment
ASSEMBLY PROCEDURE
Fitting the rear wheels
Screw M10 x 100: 2
Castor wheels 71369: 2
Locking nuts M10: 2
Welded frame K0835: 1
1- Insert the screws from the top into the holes at the ends of the tube as shown in the picture;
2- Place the wheels on the screws as shown in the picture;
3- Mount and tighten the locking nuts on the bolts to fasten the wheels using the 17 mm spanner and
the H8 Allen key.
Fitting the front wheels
Screw M10 x 100: 2
Castor wheels 71369 : 2
Locking nuts M10: 2
Support leg 55580 2
1- Insert the screw from the top into the hole at the end of the tube as shown in the picture;
2- Place the wheels on the screws as shown in the picture;
3- Mount and tighten the locking nut on the bolt to fasten the wheel using the 17 mm spanner and the H8
Allen key.
4- Repeat the previous steps on the second leg.
MULTITOOL TRUCK
Allen key: H8
17mm open-end spanner
Allen key: H8
17mm open-end spanner
Washer 43253 : 2