Maintenance - STERWINS PCS 46 Manual De Instrucciones

Do not use an unstable foothold or ladder.
Do not cut above shoulder height.
Always use your both hands to grip the saw.

MAINTENANCE

Before cleaning, inspecting or repairing your unit, make sure that engine has stopped and is
cool. Disconnect the spark plug to prevent accidental starting.
MAINTENANCE AFTER EACH USE
F21
1. Air filter
2. Oiling port
F22
Lubrication
orifice
3. Guide bar
F23
Chain guide
furrow
4.Others
Lubrication orifice
F24
Sprocket teeth
Dust on the cleaner surface can be removed by tapping a corner of
the cleaner against a hard surface. To clean dirt in the meshes, split
the cleaner into halves and brush in gasoline. When using
compressed air, blow from the inside. (F21)
To assemble the cleaner halves, press the rim until it clicks.
Dismount the guide bar and check the oiling port for clogging. (F22)
When the guide bar is dismounted, remove sawdust in the bar groove
and the oiling port. (F23)
Grease the nose sprocket from the feeding port on the tip of the bar.
(F24)
Check for fuel leakage and loose fastenings and damage
to major parts, especially handle joints and guide bar mounting.. If any
defects are found, make sure to have
operation again.
40
them repaired before