STERWINS PCS 46 Manual De Instrucciones página 41

PERIODICAL SERVICE POINTS
1. Cylinder fins
Dust clogging between the cylinder fins will cause overheating of the engine. Periodically
check and clean the cylinder fins after removing the air cleaner and the cylinder cover.
2. Fuel filter
(a) Using a wire hook, take out the filter from the filler port.
(b) Disassemble the filter and wash with gasoline, or replace with new one if needed.
NOTE
After removing the filter, use a pinch to hold the end of the suction pipe.
When assembling the filter, take care not to allow filter fibers or dust inside the suction
pipe.
3.Oil tank
With a wire hook, take out the oil filter through the filler port and clean in gasoline. When
putting the filter back into the tank, make sure that it comes to the front right corner. Also
clean off dirt in the tank.
F25
0.65 mm.
F26
4. Spark plug (F25)
Clean the electrodes with a wire brush and reset the
gap to 0.65 mm as necessary.
5. Sprocket (F26)
Check for cracks and for excessive wear interfering
with the chain drive. If the wearing is found
obviously, replace it with new one. Never fit a new
chain on a worn sprocket, or a worn chain on a new
sprocket.
41