Kärcher OC 3 Foldable Manual Del Usuario página 11

Symbols on the device
Do not immerse the device in liquids.
Do not scoop any liquids.
Device description
Description of the device
See graphics page for illustrations
Illustration A
Carrying handle
1
Clamp mount
2
Cover
3
water reservoir
4
Fine filter
5
Charger
6
Charging cable
7
USB-C plug
8
USB-A plug
9
Cover
10
Charging socket
11
Charging state LED
12
Type plate
13
Operating state LED
14
ON/OFF button
15
Nozzle
16
Low pressure gun
17
Trigger
18
Low pressure hose
19
Blink codes
Operating
state LED
Charge
state LED
Initial startup
Battery charging
1. Unfold the water reservoir, see chapter Establishing
the water supply.
2. Charge the battery.
The device is switched
on.
Low battery voltage
warning (approx. 2
minutes operating time
remaining).
Malfunction, see chap-
ter Troubleshooting
guide.
Battery is being
charged.
The battery is fully
charged.
English
a Release the cover from the charging socket and
swing it upwards.
b Plug the USB-C plug of the charging cable into
the charging socket.
c Plug the USB-A plug of the charging cable into
the charger.
d Plug the charger into a mains socket.
Illustration B
Note
The charging state LED flashes during the charging pro-
cess. It lights up for 10 min. when the battery is fully
charged.
For charging time, see chapter Technical data.
After charging
3. Pull the charger out of the mains socket.
4. Pull the USB-C plug out of the charging socket.
5. Swivel the cover on the charging socket downwards
and press it firmly.
Establishing the water supply
ATTENTION
Risk of damage due to improper water supply
Damage to the device and accessories.
Only fill the water reservoir with clean and clear water.
Do not fill the water reservoir with any detergents, pes-
ticides or other additives.
Do not immerse the device in liquids.
Do not scoop any liquids with the device.
1. Unfold the water reservoir:
a Remove the lid from the water reservoir.
b Keep the bottom of the water reservoir pressed
down with your hand.
c Pull the carrying handle upwards with the other
hand.
Illustration C
2. Hang the lid on the water reservoir.
Illustration D
3. Remove the low-pressure gun and the low-pressure
hose as far as possible from the water reservoir.
4. Fill clean and clear water into the water reservoir up
to the "MAX" mark at the most.
Illustration E
5. Attach the lid to the water reservoir.
Note
Guide the low-pressure hose through the recess in the
cover so as not to pinch it.
Illustration F
6. For one-handed transport, press the low-pressure
hose on the carrying handle into the two clamp hold-
ers.
Illustration G
Operation
1. Place the device on a level, horizontal surface.
Operation without detergent
ATTENTION
Risk of damage if dry running!
Dry running damages the pump of the device.
Do not switch on the device if no water is present in the
water reservoir.
Switch off the device as soon as the water reservoir is
empty.
Switch off the device if it does not build up pressure
within 2 minutes. Then proceed according to the instruc-
tions in chapter Troubleshooting guide.
11