Publicidad
Idiomas disponibles
Idiomas disponibles
supporting a weight of at
least 45 kg.
The fixture must be able to
•
support the weight of the
moving fan without moving.
Make
sure
•
installation site the blades do
not come into contact with
any objects. Always leave a
minimum clearance of 150
mm from the tip of the blades
to the wall or ceiling. Keep
in mind that the larger the
space, the better the airflow
of the fan.
Do not use in an open space
•
or where it can be exposed to
water or moisture.
Only the fans with a support
•
rod or bar can be installed on
sloping roofs where the angle
of inclination does not exceed
25º. This model cannot be
installed on sloping roofs.
If the product is going to be
•
installed in a suspended
ceiling or drywall ceiling you
will need to find the right
section of a beam that can
bear 45 kg, or a 2"x4" support
to be placed between beams
and will serve as the fan
support.
Safe use
Electric
Humidity infiltrations
may
that
at
the
shock
risk:
cause
electric
shocks.
Do not submerge the unit or
•
the cable in water or spray it
with any liquid.
Turn the fan OFF when
•
is not in use and before
disassembling or cleaning.
Fully assemble the fan before
switching on again.
The fan cannot be started in
•
a room with a gas appliance
running at the same time.
The fan must be turned off
•
and
stopped
before reversing the direction
of the fan (Winter mode). This
will prevent any damage to
the fan motor or controller.
Do not insert any objects into
•
the fan blades while they are
rotating. This can damage
them and upset the balance of
the ventilator, even knocking
it down.
The
use
•
not recommended by the
manufacturer
hazardous.
Do not connect the fan motor
•
to a current regulator. It
could
give
performance (engine buzzing)
and cause engine damage.
Do not operate if the fan
•
housing is damaged.
If the cord is damaged, it
•
must be replaced by the
manufacturer,
completely
of
attachments
may
unsatisfactory
its
service
EN
be
31
Publicidad
