Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Fan body:
• First loosen the two screws located on
the top part of the fan body, where the
downrod is going to be inserted.
• Remove the safety pin from the
downrod and save it. (Pic. 2)
• Then follow this sequence: Insert the
down rod through: the top cover and the
bottom cover (pic. 3)
• Introduce the cables through the down
rod too (Pic. 4)
• If you were unable to thread the cables
through the downrod we suggest that
you remove the hemisphere located on
top of the downrod (pic. 5), proceed as
follows:
• Remove the upper screws located
on the rubber hemisphere and save
them. Keep in mind that one of them
will hold the earth wire extension
cable (pic. 5.3) Remove the safety pin
and save it together with the screws
(pic. 5.2 and 5.1) Then thread the
cables and fix it again.
• To fix the hemisphere again: Insert
the safety pin in the holes on the top
part of the down rod (pic. 5.1) Then
bring up the rubber hemisphere until
all the holes are aligned (pic. 5.2)
Last, fix it with the screws you have
removed earlier and fix the earth
wire with one of them (pic 5.3)
• Once you have inserted the cables,
Fit the rod in the motor housing and
insert again the safety pin previously
removed. Then, tighten the screws of
the motor housing which have been
loosened before (pic. 6)
• Once you have finished, adjust the
bottom cover and hide the connection
between the down rod and the motor
housing. (Pic. 7)
How to assemble the blades:
• To assemble the blades, you need to
remove the LED light plate. In order to
do this, remove the screws from the
plate and save them together with the
plate (fig. 8).
• Insert the blades in the slots and align
34
the two holes on the blades with the
two holes in the main structure of the
lamp (pic. 9).
• Fix and tighten using the screws
supplied. The blades are designed to fit
perfectly. The screws must be vertical
with respect to the blade. Tighten
evenly the screws to the blades to
prevent the fan from swinging (pic. 10).
Keep in mind that you need to turn the
light fixture mounting bracket to gain
visual access to the support of every
blade.
• Once you have assembled all blades you
have to install the LED light plate again:
• Put it back in the initial position,
threading the cables coming out
from the motor through the centre of
the panel (pic. 11)
• Place the light plate so that the holes
are aligned with the holes for the
screws you have previously removed
from the light support. Then fix the
screws on the LED plate. Please,
make sure the lighting kit is well
fixed after you have tightened the
screws (pic. 11).
• Now fix LED light kit. This is supplied
with a magnetic bracket or with screws.
To proceed, first connect wires from
the motor to wires from LED light kit.
Once connected, match light kit to light
bracket. If your model has magnets,
bring it closer to it so it is magnetised
and fixed to support plate, but if your
model has screws use them to fix it to
support plate. (Pic. 12).
Electrical connections:
• Put the fan on the ceiling bracket
by introducing the down rod in the
receiver bracket and turn it until you
hear a "click" sound, insert the slot
located on the hemisphere of the down
rod, in the tab of the receiver bracket.
(pic. 13).
• Then we can proceed to do the pertinent
electrical connections. See image 05 on
page 9:
• First place the receiver between the
Publicidad
