SNOWJOE SUN JOE iON100V-10PS-CT Manual Del Operador página 10

Fig. 2
2. Remove the cutting bar and chain from the mounting
surface (Fig. 3).
Fig. 3
3. Remove the old chain from the bar.
NOTE: When you first purchase your pole chain saw, the
chain and bar will come separately with the saw. Refer
only to the instructions for fitting the chain and bar (start
with step 4). Should you need to replace the chain in the
future, follow all the steps in this section.
4. Lay out the new saw chain in a loop and straighten
any kinks. THE SHARP SIDE OF THE TEETH MUST
FACE AWAY FROM YOU IN THE DIRECTION OF THE
CHAIN ROTATION INDICATED ON THE GUIDE BAR
turn the loop over (Fig. 4).
Fig. 4
Chain rotation
Chain drive link
Sprocket
cover
Sprocket
cover nut
Cutting bar
Chain
. If the teeth face backwards,
Sharp cutting edge
5. Starting at the tip, mount the chain drive links into the
bar groove, leaving a loop at the back of the bar. The
chain will loosely fit until it is placed on the sprocket.
(Figs. 5 & 6)
NOTE: Make certain of the direction of the chain
backwards, the saw will vibrate abnormally and will
not cut.
Fig. 5
Fig. 6
6. Hold the chain in position on the bar and place the loop
around the sprocket. Fit the bar against the mounting
surface so that the bar stud is in the long slot of the
bar and the adjusting pin is in the chain tension pin
hole (Fig. 7).
Fig. 7
Chain tension pin hole
(with adjusting pin)
10
.If the chain is mounted
R
Loop
Bar stud
Sprocket