Publicidad
Idiomas disponibles
Idiomas disponibles
5. To turn the tool ON, push and hold the safety button
(on either side) with your thumb and then squeeze the
On/Off switch with your fingers. Once the tool is running,
you can release the safety lock button and proceed with
operation (Fig. 26).
NOTE: Do not press the On/Off switch until you are ready
to make a cut.
Fig. 26
On/Off switch
6. To turn the tool OFF, release the On/Off switch.
7. Push the battery releasing button and pull out the battery.
Cutting Tips
Proper Cutting Stance
• Balance your weight with both feet on solid ground.
• Your body should always be to the left of the chain line.
• The most typical cutting application is to position the
unit at an angle of 60° or less depending on the specific
situation (Fig. 27). As the angle of the pole chain saw shaft
to the ground increases, the difficulty of making the first
cut (from the underside of limb) increases.
Fig. 27
Safety button (on
both sides)
60º MAXIMUM
Basic Cutting Procedure
This unit is designed for trimming small branches and limbs
up to 9.5 in. (24.1 cm) in diameter depending on the wood
type. Practice cutting a few small limbs using the following
technique to get the "feel" of using the saw before you begin a
major sawing operation.
• Take the proper stance in front of the tree with the
saw OFF (Fig. 27).
• Squeeze the trigger and let the chain accelerate to full
speed before entering the cut.
• Keep the saw running the entire time you are cutting;
maintain a steady speed.
• Allow the chain to cut for you; exert only light downward
pressure. If you force the cut, damage to the bar, chain or
unit can result.
• PUSH and PULL – This reaction force is always opposite
to the direction the chain is moving when it is in contact
with the wood. Thus, the operator must be ready to
control the PULL when cutting on the bottom edge of the
bar, and PUSH when cutting along the top edge.
• Do not put pressure on the saw at the end of the cut.
Pruning
Pruning is the process of trimming limbs from a live tree.
• Remove long branches in several stages.
• Cut lower branches first to allow the top branches more
room to fall.
• When pruning trees, it is important not to make the
finishing cut next to the main limb or trunk until you have
cut off the farthest lying limb. This will reduce the weight
and prevent stripping the bark from the main member.
• Under cut the branch 1/3 through for your first cut.
Your second cut should over cut to drop the branch off
(Fig. 28). Be prepared to balance the weight of the pole
chain saw when the limb falls.
Load
Second Cut
First Cut
1/3 Diameter
Finishing Cut
Fig. 28
• Now make your finishing cut from the topside of the
branch smoothly and neatly against the main member so
the bark will grow back to seal the wound.
17
Publicidad
