Publicidad
Idiomas disponibles
Idiomas disponibles
This temperature is specific according to the climatic class of the device: N-ST: This
refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to
38 °C.
Avoid locating your fridge near a heat source, eg, cooker, boiler or radiator. Also, avoid direct
sunlight in out-buildings or sun lounges. If you are placing your fridge in an out-building such
as a garage or annex ensure that the Fridge is placed above the damp course, otherwise
condensation will occur on the cabinet. Never place the fridge in a wall recessed or into fitted
cabinets or furniture when your fridge is working, the grille at the back may become hot and
the sides warm. It must therefore be installed so that the back of the fridge has at least 9cm
of free space and the sides have 2 cm.
Do not drape the fridge with any covering.
Leveling the fridge
If the fridge is not level, the door and magnetic seal alignment will be affected and may cause
you Fridge to work incorrectly. Once the fridge is placed in its final location, adjust the leveling
feet at the front by turning them.
Cleaning before use
Wipe the inside of the fridge with a weak solution of bicarbonate of soda. Then rinse with warm
water using a damp sponge or cloth. Wash the baskets and shelves in warm soapy water and
dry completely before replacing in the fridge.
Before plugging in
Check that you have a socket which is compatible with the plug supplied with the fridge.
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FRIDGE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30
minutes before switching back on to allow the coolant fluid to settle.
Before filling your fridge
Before storing foods in your fridge, turn the fridge on and wait for 4 hours, to make sure it is
working properly and to allow the fridge to fail to the correct temperature.
Reverse the door
The side to which the refrigerator door opens can be altered on the right side to the left, if the
place of installation so requires.
1. Remove the screws (6) securing the top cover (7) and remove it.
2. Remove the two screws (1) securing the right upper hinge (5) to the structure and
remove.
3. Lift the door and place it on a padded surface to prevent scratching.
4. Remove the two screws (8) securing the lower hinge (2) and remove.
23
Publicidad
