Publicidad
Idiomas disponibles
Idiomas disponibles
Moving the unit
▪ Location
Do not place your fridge near a heat source, for example. Stove, boiler or radiator. Also, avoid
direct sunlight.
▪ Fridge Upgrade
Make sure the fridge is level. Use the rotatable adjustable feet at the front. If the fridge is not
level, the doors and magnetic sealing alignments will be affected and may cause malfunctions.
▪ Do not turn on the fridge for 4 hours
After any movement, it must not be connected for 4 hours. This delay allows the coolant to be
adjusted.
▪ Installation
Let your device breathe. Heat is released from the walls so it is important to leave a circulation
of air around your device.
Turn off your appliance
▪ If the unit is not likely to operate for a long period of time:
▪ Remove all food from your appliance from the refrigerator.
▪ Switch off the appliance by setting the thermostat to position 0.
▪ Unplug the appliance.
▪ Clean it thoroughly.
▪
Keep the door open to prevent odors from rising.
Energy saving tips
• The refrigerator should be located in the coolest area of the room, away from heat
producing appliances or heating ducts, and out of the direct sunlight.
• Let hot foods cool to room temperature before placing in the refrigerator. Overloading
the refrigerator forces the compressor to run longer. Foods that freeze too slowly may
lose quality, or spoil.
• Be sure to wrap foods properly, and wipe containers dry before placing them in the
refrigerator. This cuts down on frost build-up inside the refrigerator.
• Refrigerator storage bin should not be lined with aluminum foil, wax paper, or paper
toweling. Liners interfere with cold air circulation, making the refrigerator less efficient.
• Organize and label food to reduce door openings and extended searches. Remove as
many items as needed at one time, and close the door as soon as possible.
Changing the light bulb
This appliance consists of light-emitting diodes (LEDs). This type
of diode cannot be changed by the consumer. The lifetime of
these LEDs is normally sufficient for no change to be made. If
however, and despite all the care taken during the manufacture
of your appliance, the LEDs were defective, please contact your
after-sales service for any intervention.
29
Publicidad
