Packard Bell DVD DIVX 450 PRO Guia Del Usuario página 6

UK
S DVD
ETTING UP YOUR PLAYER
Box contents
1. Remote control
2. SCART cable
3. User's Guide & Service Guide
4. Batteries
Inserting remote control batteries
Open the lid of the battery compartment and install 2 AAA batteries.
Assure correct placement.
Connections
1. Before connecting, make sure to turn off the power of each appa-
ratus.
2. After finishing connection, turn on the power again.
The AV cable (optional) is colour coded.
Yellow plug -------- video terminal (yellow)
White plug --------- left audio terminal (white)
Red plug ----------- right audio terminal (red)
Please make sure that colours of connectors and plugs correspond.
DVD player and TV set
Depending on the connectors that are available on your TV set, you
may need an additional cable. Please check your TVs documentation
for the best possible connection.
You may need to use the Video Out and Progressive Scan buttons to
set the video output mode correctly. Please check the table below.
VIDEO SCANNING
OUTPUT PORT
Interleaved
VIDEO
S-VIDEO Interleaved
SCART Interleaved
Y/Cb/Cr Interleaved
Y/Pb/Pr Progressive scan
DVD player and Amplifier or Decoder
DVD player and VCR
VIDEO OUTPUT
MODE MODE
CVBS, CVBS+YUV,
CVBS+S-VIDEO
CVBS+S-VIDEO
RGB
CVBS+YUV
PSCAN
DVD player and Y Cb/Pb Cr/Pr or SCART
Setting up your TV set
If the picture does not appear correctly on your TV set, you should
check your TV's settings. Please refer to your TV's documentation.
O
PERATION INSTRUCTIONS
Before using your DVD player, please prepare the following:
1. Switch on your TV set and select AV mode.
2. If connected with an amplifier, switch on the amplifier and select
DVD input.
3. Switch on the DVD player.
Step 1
Press the Open/Close button on the remote control to open the tray.
Step 2
Insert the disc and press the Open/Close button
player will automatically recognise the disc type. Press the Play
button to play a disc.
Step 3
Press the Power button on the remote control, the unit will
switch into standby mode; press the button again to resume.
Disc playback
After inserting a disc the unit will start playback.
If there is a DVD disc, the unit will show the menu or the titles.
If there is an audio CD, the unit will play the first tune.
Pause button: Use this button to interrupt/resume display.
Prev button: To select the previous song or chapter.
Next button: To select the next song or chapter.
F
UNCTION BUTTONS
Screen display
When the unit plays a disc, press the OSD button
to browse through several options.
For DVD discs
Press the OSD button once:
Displays current title, chapter and the total number
of titles and chapters on the disc.
Press again to show the remaining time.
Press again to show the elapsed time.
Press again to show the remaining chapter time.
And again to switch off OSD display.
For SVCD, VCD and CD discs
Note that display may vary according to disc type.
again, the
-
6