Publicidad
Draining the dirty water
Drain the water with the machine disconnected from the power supply.
The dirty water tank drain hose is at the back of the machine on the right.
To empty the tank:
►
move the machine near a drain;
►
detach the drain hose (fig. A, ref. 7) from its seat by holding it near the fixing spring and pulling horizon-
tally;
►
keeping the end of the hose as high as possible and remove the cap;
►
lower the end of the hose gradually, controlling the intensity of the flow of water by adjusting the height
from the ground;
►
check the amount of dirt left in the dirty water tank and if necessary wash it out;
►
close the drain hose with the cap. Check that it is tightly closed and replace the hose in its housing.
►
You are then ready to wash and dry again.
Draining the clean water
Drain the water with the machine disconnected from the power supply.
To empty the tank:
►
move the machine near a drain;
►
unscrew the cap (fig. G, ref. 1);
►
when the detergent tank is completely empty, screw the cap back on (fig. G, ref. 1).
The water and detergent solution can also be used to wash the dirty water tank.
If the machine is not used for some time, remove the squeegee and brush (or drive disk), wash them and put them
away in a dry place (preferably in a bag or wrapped in plastic film) away from dust.
Make sure the tanks are completely empty and perfectly clean.
Disconnect the machine from the power supply (depending on the model, unplug from the mains or disconnect
the connector from the battery wiring).
Battery models: charge the batteries completely before storing them. During long periods of inactivity, you should
charge the batteries regularly (at least once every two months) to keep them constantly at maximum charge.
If you do not charge the batteries regularly, they may be irrevocably damaged.
BATTERY MAINTENANCE AND CHARGING
The batteries give off flammable fumes. Put out all fires and hot embers before checking or topping up
Perform the operations described above in a ventilated room.
To avoid permanent damage to the batteries, do not run them down completely.
Remember that when the corresponding red light (fig. C, ref. 2) flashes on the control panel, you must charge
the batteries.
Charging procedure
►
if the machine does not have an on-board charger, connect the external battery charger connector to
the battery wiring connector.
►
if the machine has an on-board battery charger, connect the on-board battery charger power cable (fig.
H, ref. 1).
In the case of gel batteries, use a charger specific for gel batteries only.
DANGER
Use suitable personal protection devices.
DANGER
Use suitable personal protection devices.
i INFORMATION
PERIODS OF INACTIVITY
IMPORTANT
DANGER
Do not check the batteries by sparking.
the batteries.
IMPORTANT
GB
30
Publicidad
