NODOR NorCook IH N8205 BK Manual De Instrucciones página 25

Installation
All operations relative to installation (electric connection) should be carried out by skilled personnel
in conformity with the rules in force. As for the specific instructions see part pertaining to installer.
Switching the Touch Control ON/OFF
After mains voltage is applied the control initializes for approx. 5 seconds before it is ready for opera-
tion. After a reset all displays and LEDs glow for approx. 2 seconds. When this time is over all displays
and LEDs extinguish and the control is in the stand-by mode.
Press the ON/OFF (1) button to switch the touch control on. An acoustic signal will be emitted, and a
light sequence will turn on. Then, the hob is ready to be used.
If a cooking zone is in the "hot" status, the display (5) shows a static "H". After switching-ON the
electronic control remains activated for 30 seconds. If no cooking zone or timer selection follows
within this period of time, the electronic control automatically switches back into the stand-by-mode.
The control can only be switched-ON if it identifies the ON/OFF key (1) alone being operated. Should
it recognize key activation other than that, the control remains in the standby- mode.
If the child safety feature is active when switching on, all cooking zones (5) show "L", (LOCKED). If
the cooking zones are in a "hot" status, the display (5) shows "L" and "H" in alternation. When the
Touch Control is ON it can be switched- OFF at any time by operating the ON/OFF key (1). An acous-
tic signal will be emitted, and the hob will go in to standby mode. This is also valid if the control has
been locked (activated child safety feature). The ON/OFF key has always priority in the switch-OFF
function (1).
Functionality Slider TC
The touch control comprises touch displays that light up according to the following criteria:
· The keys of the functions available light up with low intensity.
· The key selected lights up with a higher intensity.
· The keys for functions that are not available remain unlit.
Slider (2): sensor technology of Slider TC allows an adjustment of the cooking levels (1 – 9) as the
timer value (1-99) by touching and pulling the finger over the designated area. Pulling to the right is
increasing and to the left is decreasing accordant value. Moreover, a direct selection of the designat-
ed value is also possible on the slider area.
Nsense: Automatic cookware detection
Place a suitable piece of cookware on the hob. Depending on its position, the designated slider (2)
will automatically be activated. Select the power level by sliding your finger over the control (2).
If you lift the cookware, the display (5) will show the symbol
cookware back after this time, the slider will switch off.
If you place a piece of cookware that is too small or made of unsuitable material, the slider (2) and the
display (5) will not be activated.
If an error occurs when detecting the cookware (e.g. a large pan is detected as two pots during the
hob ignition), lift the cookware for more than 2 seconds and place it back on the hob.
Nprecise: Power levels
Up to 17 different power levels can be selected for each piece of cookware (from 1 to 9, with incre-
ments of 0.5). The selected value will be shown on the display (5) to the left of the designated slider.
To stop cooking, select power level 0 on the slider (2) designated to the cookware.
Power management
This function is designed to avoid overloading the system with excessive power demand. If high ou-
tputs have been selected for two pieces of cookware placed close to one another, the output of the
piece of cookware that was placed first will automatically be reduced if necessary. The designated
60819630.20.07.2020.indd 25 60819630.20.07.2020.indd 25
for 10 seconds. If you do not put the
1/10/20 10:22 1/10/20 10:22