NODOR NorCook IH N8205 BK Manual De Instrucciones página 26

Idiomas disponibles

display (5) will flash for 3 seconds before switching to a lower power. During these 3 seconds you can

select a lower power for the other piece of cookware if you wish. Otherwise, the power supply for the

first piece of cookware will automatically be reduced.

Nheat: Residual heat indicator

This safety function serves to identify areas of the glass that have a temperature above 65°C, which

could cause burns if touched.

The display (5) designated to the hot area displays the letter "H" whether the hob is switched on

or off. If cooking is in progress, then the display (5) designated to the cookware will only show the

selected power level.

Nfollowme: Power transfer

This function allows you to change move cookware without having to select its power level again.

When you move a piece of cookware, the system will recognise the movement, cancel the slider (2)

of the previous position and activate the control (2) designated to the new position, preserving the

parameters it had in the previous position (power, timer).

The position must be changed in less than 10 seconds. If more than 10 seconds pass between you

lifting the cookware and putting it back, the parameters will be eliminated from the memory and the

cookware's control (2) will be switched off.

Only one action can be performed on one piece of cookware at once. Performing simultaneous ac-

tions on more than one piece of cookware (add, move) can make it difficult for the control to identify

them correctly. Simultaneous actions are those carried out with a time difference of less than 2 se-

conds. However, removing more than one piece of cookware from the hob at once is not a problem.

In the settings menu (code U6) you can customise the confirmation of the parameters in the new

position. If confirmation is required, the cookware will not receive any power until you press the

(flashing) slider (2) to confirm. If after 15 seconds it has not been pressed, then the power will auto-

matically drop to 0.

Nboost+: Booster function

The Booster function allows the power supplied to the cookware to be increased above its nominal

value for 10 minutes. Once this time has passed, the power will automatically decrease to level 9. This

function is designed to heat or boil large amounts of water in a short time.

Due to its high power, the Booster function should only be used when cooking with water. Oil or fat

could cause burns.

To activate this function, press the key (7) designated to the desired cookware. Pressing once will

activate the first Booster level and P1 will appear on the display (5). Pressing twice will activate the

second Booster level (which is more powerful) and P2 will appear on the display (5).

To cancel this function, select any other power level on the slider (2).

60819630.20.07.2020.indd 26

1/10/20 10:22

Norcook ih n9205 bk