cookware can also have a significant impact on the noise level. Should any disturbing noises occur,
please consider these suggestions:
· Change the position of the cookware slightly.
· Make sure that there are no foreign bodies between the ceramic hob and the bottom of the
cookware (grains of salt, for example).
· Make sure that the lids of the cookware cannot vibrate.
· Try using other cookware. Cookware with a composite base is more likely to cause noise.
Settings menu (F9)
This menu allows you to customise certain functions.
To access the settings menu, press the on/off key (1) to switch the hob on. Then press and hold the
settings key (12) for at least 1 second. The control on the right-hand side will light up the settings
menu.
The setting parameter code is shown in the display (R) on the top row. Select the desired parameter
using the upper slider (S).
The parameter value is shown in the display (T) on the bottom row. To modify it, you must use the
lower slider (U).
To discard the changes and leave the settings menu, press the settings key (12).
To save the changes and leave the settings menu, press the on/off button (1) for 2 seconds.
If no key is pressed for 1 minute, the system automatically leaves the settings menu without saving
the changes.
Code
U2
Key sound vo-
lume
U3
Warning sound
volume
U4
Contrast between
dim and bright
light
U5
Power display
U6
Confirmation of
the parameters
after moving the
cookware
U7
Timer completion
notice
60819630.20.07.2020.indd 32
60819630.20.07.2020.indd 32
Parameter
Possible values
0-1-2-3
0-1-2-3
0-1-2-3
0-1-2
0-1-2
Comments
0: minimum
3: maximum
0: minimum
3: maximum
0: minimum
3: maximum
0-1
0: 1 digit
1: 2 digits
0: It does not require con-
firmation
1: Confirmation is required
from power level 7 (inclu-
ded)
2: It always requires con-
firmation
0: beeping for 120 seconds
2: beeping for 120 seconds
2: one short beep
1/10/20 10:22
1/10/20 10:22