Flex LD 18-7 125 R Instrucciones De Funcionamiento Originales página 15

LD 18-7 125 R/LD 18-7 150 R
Safety instructions
WARNING!
Read all safety instructions and other
instructions. Failure to observe the safety
instructions and other instructions may
result in an electric shock, fire and/or serious
injuries . Keep all safety instructions and
other instructions in a safe place for the
future.
This electric power tool must be used as

a sander. Read all safety warnings,
instructions, illustrations and speci-
fications provided with this power tool.
Failure to follow all instructions listed
below may result in electric shock,
fire and/or serious injury.
Operations such as sanding, wire

brushing, or for polishing and cut-off are
not recommended to be performed with
this power tool. Operations for which the
power tool was not designed may create
a hazard and cause personal injury.
Do not use accessories which are not

specifically designed and recommen-ded
by the tool manufacturer. Just because
the accessory can be attached to your
power tool, it does not assure safe
operation.
The rated speed of the accessory must

be at least equal to the maximum speed
marked on the power tool. Accessories
running faster than their rated speed can
break and fly apart.
The outside diameter and the thickness

of your accessory must be within the
capacity rating of your power tool.
Incorrectly measured insertion tools
cannot be adequately shielded or con-
trolled.
Sanding discs, sanding pads or other

accessories must fit exactly on
the grinding spindle of your electric
power tool. Insertion tools, which do not
fit exactly on the grinding spindle of the
electric power tool, rotate unevenly,
vibrate violently and may result in loss of
control.
Do not use a damaged accessory.

Before use, always check insertion tools
for splinters and cracks, sanding pad for
cracks, wear and severe abrasion. If
power tool or accessory is dropped,
inspect for damage or install an
undamaged accessory. After inspecting
and installing an accessory, position
yourself and bystanders away from the
plane of the rotating accessory and run
the power tool at maximum no-load
speed for one minute. Damaged
accessories will normally break apart
during this test time.
Wear personal protective equipment.

Depending on application, use face
shield, safety goggles or safety glasses.
If appropriate, wear a dust mask, hearing
protection, protective gloves and/or a
special apron which protect you from
small sanding and material particles.
The eye protection must be capable
of stopping flying debris generated by
various operations. The dust mask or
respirator must be capable of filtrating
particles generated by your operation.
Prolonged exposure to high intensity
noise may cause hearing loss.
Keep bystanders a safe distance away

from work area. Anyone entering
the work area must wear personal
protective equipment. Fragments of
workpiece or of a broken accessory may
fly away and cause injury beyond
immediate area of operation.
Hold power tool by insulated gripping

surfaces only, when performing an
operation where the cutting accessory
may contact hidden wiring or its own
cord. Cutting accessory contacting a
"live" wire may make exposed metal
parts of the power tool "live" and shock
the operator.
Position the cord clear of the spinning

accessory. If you lose control, the cord
may be cut or snagged and your hand or
arm may be pulled into the spinning
accessory.
15