Flex LD 18-7 125 R Instrucciones De Funcionamiento Originales página 21

LD 18-7 125 R/LD 18-7 150 R
Check position of the guard.

The brush ring should protrude over
the sanding pad by approx. 0–1 mm.
If required, correct (see "Adjusting the
guard").
Insert the mains plug into the socket.

Switch on the electric power tool

(without locking the button) and leave it
running for approx. 30 seconds.
Check for imbalances and vibrations.
Switch off the electric power tool.

Adjusting the guard
NOTE
The brush ring should protrude over the
sanding pad by approx. 0–1 mm. To
compensate for wear on the diamond
sanding pad, the height of the guard can be
adjusted.
Loosen clamping lever on guard hood.

Set the guard hood to the required height.

Tighten the clamping lever.

NOTE
If the clamping force decreases, the
clamping can be adjusted by tightening the
hexagon socket screw on the clamping
lever.
Connecting an extraction system
NOTE
It is recommended to use a FLEX Class M
dust extractor.
Attach extraction hose to the connector

on the guard hood.
Attach power cord to the extraction hose

using the enclosed cable holders (3x).
Connect extraction hose to the dust

extraction system. Follow the operating
instructions for the dust extraction
system! Check the attachment! If
required, use an appropriate adapter.
NOTE
If your dust extractor requires a special
connection (i.e. a connection other than
the 32 mm/36 mm standard connection
which is included with the electric power
tool), contact your dust extractor supplier
to obtain the appropriate adapter.
21