Sansui A-M7 Manual De Instrucciones página 6

x=
—
a
O
=<
ul
Operating procedures
* Rotate the MIC MIXING control to its leftmost ''MIN" position.
* Set the LOUDNESS switch to the released OFF position.
After playback, release the TAPE switch.
Recor' Play
Depress the PHONO input selector switch.
7 cer aaeee | ¢-—
eae] | Ts
= ee es
0000
Adjust the volume, balance and tone controls.
Any humming noise heard could be caused by improper pin plug con-
nections or a disconnected GND wire. Check the ground wire connec-
tion.
Operate the turntable and play the record.
pie lt a
Using a Component Connected to AUX Terminals
1. Depress the AUX input selector.
2. Operate the connected component.
3. Adjust the volume, balance and tone controls.
Tuner Reception
Depress the TUNER input selector.
Operate the tuner and tune in the station.
Adjust the volume, balance and tone controls.
For optimum reception, an antenna should be selected in accordance
with the signal condition and it should be erected in the proper place.
Refer to the Operating Instructions of the tuner and select the an-
tenna.
si oe a