Descargar Imprimir esta página

CM TORNADO TOR07505 Manual De Funcionamiento, Mantenimiento Y Piezas página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

TO LOOSEN OR LOWER LOAD
Power operation may cause structural damage or premature wear
that in turn may cause a part to break and allow the load to fall.
TO AVOID INJURY:
Operate the CM
®
TORNADO 360° lever hoist using hand power only!
Move directional lever to the unload position. Again, operate lever in
an up and down motion to increase the distance between hooks and
thus loosen or lower the load.
LOCKED BRAKE
If a hoist which is under load is suddenly relieved of the load by
lifting the load off of the lower hook by some other means or pulling
down walls, the brake will lock.
The brake will also lock if the lower hook block is pulled tightly
against the frame.
To unlock the brake, turn the directional lever to the unload position
and pull on the lever sharply.
Turning the Free Chaining Knob with a load attached will allow the
load to release and may cause injury.
TO AVOID INJURY:
Never turn the Free Chaining Knob when the lever hoist is under load.
If the unit is not rigged in a straight line hook to hook manner, and
if the frame is not free to swivel, lever pull may break frame and
cause physical injury and loss of load.
TO AVOID INJURY:
Rig the unit in a straight line hook to hook manner and keep frame
free to swivel (See Figure 4).
Figure 4
HANDLE OPERATION — FOLDING OUT
To fold out the handle from the center position, press against the
indentation till the handle reaches the nal position. This may be
at the right or left hand side of the lever. Make sure the handle is
locking with a notable click. Keep the conical seat free from dirt.
CLICK
HANDLE OPERATION — FOLDING IN
To bring the handle back to center position, pull the handle axial against
the spring load till the handle is unlocked. Then slide it back to center
position. The handle will be kept in this position by spring load.
1.
INSPECT HOIST
Before each use and at speci ed intervals as directed in the
inspection section.
Use as directed above. Failure to do so may cause injury to you
or others.
1. DO NOT exceed capacity shown on nameplate.
2. DO NOT use to lift people or loads over people.
3. DO NOT use unless the hoist's frame and chain form a straight
line between hooks.
4. DO NOT use if the frame is in contact with any object.
5. DO NOT use if the unit is damaged or malfunctions.
6. DO NOT use extension on lever. Use hand power only.
7. DO NOT use if chain is twisted, kinked or damaged.
8
(ENGLISH)
CLICK
2.
P/N: 192034281 Rev AE Sept 2018

Publicidad

loading