Troy-Bilt 01924 Manual Del Propietário página 10

Section 4: Opecat[on
i
CAUTION
NEVER attempt to power a device requiring more amperage
than generator or receptacle can supply.
* DO NOT overload the generator. See "Don't Overload
_enerator',
120/240 Volt AC, 20 Amp, Locking
]
120 Volt AC, 20 Amp, Duplex
Receptacles
Each dupiex receptacie (Figure 6) is protected against
overioad by a push-to-reset circuit breaker.
Use a NEMA LH 4-20 piug with this receptacie. Connect a
4-wire cord set rated for 250VoHtAC ioads at 20 Amps (or
greater) (Figure 5).You can use the same 4-wire cord if you
_ian to run a i20Voit ioad.
4oWire Cord Set
/
(Neutral)
NEMA LI4o20
Y (Hot) _ X (Hot)
Ground (Green)
This receptacle powers 120/240VoltAC, 60 Hz, single
phase loads requiring up to 3,500 watts of power (3.5 I<W)
at 14.6 Amps for 240Volts or two independent 120Volt
loads at 14.6 Amps each.The oudet is protected by
push-to-reset circuit breakers.
Use each receptacle to operate 120VoltAC, single-phase,
60 Hz electrical loads requiring up to 1,750 watts
(1.75 kW) at 14.6 Amps of current. Use cord sets that are
rated for 125 Volt AC loads at 15 Amps (or greater).
COLD WEATHER
OPERATmON
Under certain weather conditions (temperatures below
40°F 14°C] combined with high humidity), your generator
may experience icing of the carburetor and/or the
crankcase breather system.To reduce this probiem, you
need to perform the following:
I. Make sure generator has ciean, fresh fuel
2. Open fuel valve (turn valve to open position).
3. Use SAE 5Wo30 oil (synthetic preferre& see engine
manual).
4. Check oil level daily or after every eight (8) hours of
operation.
5. Maintain generator following "Maintenance Schedule"
in engine manual.
6.
Shelter unit from elements.