Troy-Bilt 01924 Manual Del Propietário página 6

ASSEMBLY
Your generator reqores some assembHy and is ready for
use after it has been properHy serviced with the
recommended oiH and fuel
if you have any proMems with the assernbmy of your
generator, pmease carom the generator hempmine at
l=888=61 l =6708°
Remove Generator From Carton
o Setthe cartonon a rigid f iat surface with"ThisSideUp"
arrows pointing upward.
o Carefully open the top flaps of the shipping carton,
o Cut down corners at one end of carton from top to
bottom and Haythat side of carton down fiat.
o Remove all packing material carton fillers_ etc.
o Remove the generator from the shipping carton,
Install Wheel
Kit
The wheeH kitisdesignedto greatly improve the portabiHity
of your generator,
NOT_:: Whee[ kit is not intended for over-the-road use,
You wiHHneed a socket wrench with H/2" or H3mm sockets
and a needHe-nose pHiers to install[ this kit,
[, PHacebottom of generator cradHe on a fiat, even
surface,TemporariHy pHace unit on bHocks to ease
assembHy,
2, SHideaxHethrough both axHe mounting brackets on
cradHe frame, as shown in Figure H,
3, SHidewhee[ over axHe,
NOT_:: Be sure to install[ both wheeHs with the air
pressure vaHveon the outboard side,
4, PHacee-ring onto groove in axHe,You may add the fiat
washer if desired,
Cap Screw
\
mex
Handle AssembH,
Flat Washer
Support Leg
Hex Nut .......
Cap Screw
Axle
Wheel
/
,/
E=Ring
0